Zoom In

Lowers upto 45-50mm

These links lowers vehicles that are equipped with factory Airmatic suspension systems.
Designed and manufactured, fully adjustable zinc plated ride height sensor arms, that push fit in place of the existing steel or plastic units each new kit, has been put through the same '96 Hour Salt Test' to ensure that they will not rust.

The ball joint ends, have been specifically manufactured for each vehicle and come complete with internal spring clips to guarantee a snug fit, together with a rubber grommet to keep the units free from any dirt. The links are fully adjustable, so that you can set the new height of your car to your exact preference.

The kits are extremely easy to install using basic tools, and take no longer than 1 hour to fit, and remember that the original links can be re-fitted to the vehicle or you can re-adjust the new links to put the car back into the standard height setting for warranty purposes or selling the car.

The links can be adjusted to set your car as low as you want. We suggest a maximum drop on all cars and this will be in all instructions enclosed. Installing these links is a fully reversible process and gets away from fitting an electronic module (Costing Around £1200.00), where you have to cut into the vehicles wiring loom hoping you do not damage anything.

All kits come with a complete detailed instruction briefing that even has photographs of where the links should be installed.

Fits:
Porsche Cayenne with Air Suspension

How it works:

On the Porsche Cayenne there is a Ride Height Sensor on each of the four Control Arms. These sensors are connected to the frame of the vehicle by a short linkage called a Sensor Arm. The stock sensor arms or "links" are of fixed length and move with the suspension. They establish the position of the sensor which indicates to the computer what height the vehicle should be sitting at.

To see what these links look like on most vehicles is easy. Put the vehicle to the highest suspension setting and look straight into the wheel well on top of the front tire. You may need a flashlight. In the rear you have to look from underneath.

Our kit replaces the stock sensor arms with Fully Adjustable Aluminum Links. When extended, they change the voltage sent to the computer by the sensor. The computer then evaluates the ride height to be higher than the factory setting and compensates by lowering the vehicle.

Electronic Modules are really expensive and limit the height that your vehicle can be dropped. They often have to be hard wired which may lead to factory warranty issues. Worst of all, installation of a lowering module is extremely difficult to reverse. Setting the links to the original link length places your vehicle to the stock height. The standard/reverse thread design allows you to adjust the links on the vehicle for easy height modification.

FAQ:

Q. Will lowering my vehicle improve the handling?
A. Yes. A lower center of gravity always helps your vehicle's handling.

Q. Will the raise button inside the vehicle still work?
A. Yes.

Q. Will I need an alignment?
A. Yes. Any time a vehicle is lowered the alignment should be checked.

Q. How will the links affect my warranty?
A. The kits have never caused any issue on any vehicle. If for some reason your vehicle's air suspension failed while under warranty, we recommend installing the original links which takes no longer than 60 minutes to do.