Heating Pipe, 964 – 6-8 Horsepower more

This replica of the Porsche Germany RS lightweight factory heat duct that was used on all 3.6 litre special RS lightweight cars. This alternative is made from carbon fiber instead of cheap plastic

£119.50 – Buy Here

Air Induction Pipe for airbox right side Porsche 964 – 6-8 Horsepower more

This is a replica of the Porsche Germany RS lightweight factory air duct that was used on all 3.6 litre special RS lightweight race cars. A simple 20 minute DIY install that improved RS style engine look + improved performance.

£99.95 – Buy Here

Rennline RS Carbon FiberHeater Duct

Not recommended for ’85 models. Rennlines blower motor bypass pipe is a carbon fiber replica of the factory installed unit found on the lightweight 3.6 race cars. This pipe allows you to save 9 pounds from the removal of the factory motor assembly, but still have a functioning heater system in your car. Manufactured from ultra strong, lightweight carbon fiber and comes equipped with the aluminium fitting for the distributor breather tube. Available with or without a machined aluminium 3.6 (or 3.8) insignia plate at the top.

£275 – Buy Here

Rennline tunable semi-solid engine mount

The Rennline Tuneable mount for the 964 offers the ultimate in adjust-ability for your car. Replacing your compliant factory mounts will decrease engine movement resulting in better acceleration, handling and significantly increased shifter feel. This is the ultimate solution for almost any car and allows to tune the mounts to your driving style.

£350 – Buy Here

Oil Inlet Check Valve

Rothsport Oil Inlet Check Valves eliminated oil migration from the oil tank to the engine reducing excessive smoking on startup, typical of cars that sit for long periods of time.

£299 = Buy Here

Direct to head 45mm Throttle bodies 

These Direct-to-Head Porsche 964 / 993 Throttle Bodies are port matched with a round throttle blade. This is a direct mounting to the cylinder head, so no additional manifold is required. These throttle bodies feature round ‘Shaftless’ and knife-edged butterflies for improved airflow and performance. With the throttle blade very close to the inlet valve, the throttle response is significantly improved. Delivered Full Assembled, made from billet aluminium with a billet aluminium fuel rail, choice of inlet lengths and calibrated for your choice of Throttle Position Sensor (TPS). Engine management is the only additional part required to achieve significant power gains. Included in the kit, come Phenolic cylinder head gaskets for mounting these throttles to your engine. Our linkage setup allows you to connect directly to the existing OEM throttle cable linkage setup.

£3,750 – Buy Here

Technical Information