Enter your VAT number here and click Verify:
Your details have been verified. VAT number registered to:
,
.
Your order will now be zero rated for VAT purposes. We reserve the right to verify these details after your order request has been made and reinstate VAT if required.
Your VAT details were not recognised or were invalid. Your VAT number must be matched to your Billing Country as specified above. This is currently specified as . You do not need to enter the country code part of your VAT number as this has already been selected in your billing address details above.
The VAT number checking service is currently offline. Please supply your VAT details within the comments or special instructions field below and we will apply a VAT discount after placing your order request.
The Fabspeed Competition Link Pipes are a high-flow, motorsport-focused exhaust upgrade designed for Porsche Panamera 971 models equipped with the 3.0-litre single-turbo V6 engine from 2017 onward.
Fits:
- Porsche 971.1 Panamera V6 3.0L 2WD (330 Hp) 2017-20
- Porsche 971.1 Panamera 4 V6 3.0L 4WD (330 Hp) 2017-20
- Porsche 971.1 Panamera 4 V6 3.0L 4WD Executive 2017-20
- Porsche 971.1 Panamera 4 3.0L Turbocharged V6 Sport Turismo 2017-20
- Porsche 971.1 Panamera 4S V6 3.0L 4WD (440 Hp) 2017-20
- Porsche 971.1 Panamera 4S V6 3.0L 4WD Executive 2017-20
Designed to replace the restrictive secondary catalytic-converter section with a much freer-flowing straight-through exhaust pipe, the system reduces exhaust restriction and provides a more direct route for gases travelling through the exhaust system.
Reducing this restriction can improve exhaust gas evacuation, sharpen throttle response and support stronger engine performance while also creating a more aggressive exhaust note.
Fabspeed manufactures the Competition Link Pipes from polished T304L stainless steel, providing high-temperature durability, corrosion resistance and long-term structural strength.
Fabspeed currently reports gains of approximately:
+22 WHP
+16 lb-ft of torque at approximately 6,100rpm
Approximately 14 lb weight reduction
These are manufacturer test figures and actual performance will vary depending on vehicle condition, fuel, atmospheric conditions, calibration and other modifications.
What This Product Does:
The Competition Link Pipe replaces the restrictive secondary catalytic-converter section of the factory exhaust.
It is designed to:
- Replace the secondary factory catalyst with straight-through tubing.
- Increase exhaust gas flow.
- Reduce exhaust restriction.
- Reduce downstream backpressure.
- Improve throttle response.
- Support increased horsepower and torque.
- Increase exhaust sound.
- Reduce exhaust-system weight.
- Provide a more direct performance exhaust path.
- Complement other engine and exhaust modifications.
- Provide a bolt-on competition exhaust upgrade.
Symptoms Of Wear Or Failure:
One reason for replacing the factory catalyst section may be internal catalyst deterioration or restriction.
Possible symptoms include:
- Reduced engine performance.
- Sluggish acceleration.
- Poorer throttle response.
- Engine feeling restricted at higher RPM.
- Increased exhaust backpressure.
- Metallic rattling from the catalyst.
- Check Engine Light.
- Catalyst-efficiency fault codes.
- Excessive exhaust temperature.
- Unusual exhaust smell.
- Internal catalyst material breaking apart.
- Melted or collapsed catalyst substrate.
A suspected catalyst failure should be correctly diagnosed before replacement because another engine problem may have caused the damage.
Why Replacement Matters:
Replacing a damaged bypass pipe helps restore:
- Correct exhaust sealing.
- Maximum intended flow.
- Proper system alignment.
- Structural integrity.
- Safe clearance from surrounding components.
- Consistent exhaust sound.
Where a restrictive or deteriorated secondary catalyst is being replaced for an approved competition application, the straight-through Fabspeed pipe additionally provides:
- Reduced restriction.
- Improved throttle response.
- Increased performance potential.
- More aggressive exhaust sound.
- Reduced weight.
NOTE: In the United Kingdom, sports catalytic converters and bypass pipes do not have type approval and are not legally permitted for use on vehicles manufactured after 1st March 2001. They are not MOT compliant and cannot be used on public roads. These components are intended solely for race and track use.
For vehicles manufactured before 1st March 2001, a non-type approved sports catalytic converter may be fitted, provided it offers comparable performance to the original and the vehicle continues to meet the applicable emissions standards for its age. The vehicle must still pass an MOT test.
If you are located outside the UK, please check your local laws and regulations to ensure compliance.
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
FSPOR971V6SCB
The product you are viewing cross references to these numbers
- Porsche 971.1 Panamera V6 3.0L 2WD (330 Hp) 2017-20
- Porsche 971.1 Panamera 4 V6 3.0L 4WD (330 Hp) 2017-20
- Porsche 971.1 Panamera 4 V6 3.0L 4WD Executive 2017-20
- Porsche 971.1 Panamera 4 3.0L Turbocharged V6 Sport Turismo 2017-20
- Porsche 971.1 Panamera 4S V6 3.0L 4WD (440 Hp) 2017-20
- Porsche 971.1 Panamera 4S V6 3.0L 4WD Executive 2017-20