Metal Clamp for Front Axle C2 Tray. Porsche 986 Boxster / 996  ❭  99950765709

Metal Clamp for Front Axle C2 Tray
This original Porsche retaining clamp is used to secure the front undertray / front axle tray panel, helping keep the underbody covering correctly mounted and aligned.
Sold individually

Fits:
Porsche 986 Boxster 1997 - 2004
Porsche 996 Carrera 1998 - 2005
Porsche 996 GT3 1999 - 2005
Porsche 996 Turbo 2001 - 2005

Diagram ref no 3

This clamp is used in the front axle tray / underbody protection panel mounting system on selected Porsche 986 and 996 models.

What This Part Does / Functions
•  Secures the front axle C2 tray / undertray panel
•  Helps hold the underbody protective covering in place
•  Maintains correct undertray alignment and fitment
•  Helps prevent tray movement, vibration or rattling
•  Replaces a missing, corroded, bent or damaged original clamp
•  Supports correct reassembly after undertray removal
•  Provides OE Porsche metal clamp fitment and durability
•  Helps maintain the factory underbody panel mounting arrangement.

Why Replace This Part?
Undertray clamps are exposed to road spray, salt, dirt, heat, vibration and repeated removal during servicing. Over time, the clamp can corrode, bend, weaken or go missing. A missing or damaged clamp may allow the front axle tray to sit loose, rattle, sag or detach from its correct mounting position. Replacing it with an OE Genuine Porsche metal clamp helps restore secure undertray fitment and keeps the front underbody protection panel correctly fastened.

Common Symptoms of a Missing or Damaged Clamp
•   Loose front undertray or axle tray
•   Rattling or vibration from the front underbody area
•   Undertray panel not sitting flush
•   Missing clamp after previous service work
•   Corroded or bent clamp hardware
•   Underbody cover movement at speed
•   Poor alignment of the C2 tray panel
•   Damaged fixing point during undertray removal.

When to Replace This Part
•   When refitting the front axle tray / C2 tray
•   If the original clamp is missing, corroded, bent or damaged
•   During front undertray or underbody panel replacement
•   After front-end or underside impact damage
•   During routine servicing if undertray hardware is worn
•   When replacing broken or incorrect retaining clips
•  During restoration of the front underbody panel system

Where It Fits on the Car
This clamp fits in the front underbody / front axle tray area. It is used to retain the front axle C2 tray / underbody protective covering to the vehicle’s front underside mounting points.

Correct positioning is important to ensure the tray sits securely and does not rattle or move while driving.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

99950765709

The product you are viewing cross references to these numbers