Brake pad wear sensor, Front. Porsche Carrera GT 2003-06  ›  98061234702

Front brake pad wear sensor by OE Match this replacement wire sensor supports the vehicle’s brake pad wear warning system.

Fits

Porsche Carrera GT 2003-2006 FRONT

Check fitment for your specific vehicle (model, year, engine) before ordering.

What This Product Does

The sensor provides an electrical indication when brake pads reach their wear limit. It forms part of the warning circuit rather than measuring braking force or controlling the brakes.

Functions

• Detects when the monitored brake pad reaches its wear limit.
• Supports the dashboard brake pad wear warning.
• Provides a replacement for a worn or damaged front sensor wire.
  
  

Technical Details

• Brand: OE Match.
• Component: brake pad wear sensor wire.
• Installation position: Front.
• Application: Porsche Carrera GT, 2003–2006.
• Recorded references: 98061234702 and 98061234701.
  
  

Price shown is for each wire sensor.

Symptoms of Fault

• A brake wear warning remains illuminated after pad renewal.
• Sensor wiring shows damage or deterioration.
• Retaining clips are broken or the sensor is displaced.
  
  

A warning does not establish that the sensor alone is faulty. Inspect pad condition, wiring and connections before deciding which components require replacement.

Why Replacement Matters

Renewal is normally recommended alongside brake pad replacement, particularly if the existing sensor has worn through or suffered damage. Replacing a defective sensor helps restore the pad wear warning circuit; it does not resolve faults in discs, pads or calipers.

FAQs

Is this a complete axle set?
The stated unit is one wire sensor. Confirm the quantity needed for the planned repair.

Should the sensor be renewed with the pads?
Sensor renewal is normally recommended during pad changes. A worn or damaged sensor should not be reused.

What should be checked before fitting?
Compare the original reference, front brake application, connector and cable routing with the component being removed. Inspect the retaining clips and adjoining wiring at the same time.