Rear bumper end cap, Matt Anodised. Porsche 911 LWB 1969-73 › 90150525

This OE Match end cap provides a matt anodised finishing piece for the rear bumper on Porsche 911 LWB models from 1969–73. The supplied references identify separate Left and Right versions.

Fits

• Porsche 911 1969-73 LWB CARS
• Porsche 911 & 912 (1965-1989)=>911 1968-1973 2.2L / 2.4L / 2.7L RS LWB (F)
  
  

What This Product Does
The cap finishes the end of the rear bumper assembly. It is a trim component for exterior refurbishment or restoration, rather than a complete bumper or a rubber weather seal.

Functions

• Completes the bumper-end detail.
• Replaces a missing or damaged finishing cap.
• Provides the specified matt anodised appearance.

Technical Details

• Brand: OE Match.
• Position: Rear bumper end.
• Finish: Matt anodised.
• Left reference: 90150525121; described as a plate in the supplied diagrams.
• Right reference: 90150525221; described as a plate in the supplied diagrams.
• Diagram applications: rear bumper, 911 1970–73; rear bumper, 911 1969 onwards.

Symptoms of Fault

• Scuffing or deterioration of the visible finish.
• A missing cap leaving the bumper-end detail incomplete.
• Loose trim or an uneven fit requiring inspection of the cap and its mounting points.

Why Replacement Matters
Renewing a damaged cap addresses a small but visible exterior detail during bumper repairs or restoration. Check the surrounding trim and fixings before fitting: replacing the cap alone will not correct damaged mounting points or misaligned adjoining components.

FAQs

Which side does each reference identify?
The supplied diagrams assign 90150525121 to the Left and 90150525221 to the Right. Match the required side before selecting a version.

Is this a rear bumper seal?
No. This product is the matt anodised end cap; the diagram identifies it as a plate.

Are fixings included?
The supplied information does not confirm included hardware. Check the required screws, washers and nuts separately rather than assuming they accompany the cap.