GruppeM Air Induction Kit for Porsche 996 GT3 3.4L  ❭  FRI-0138

K&N High Performance replacement air filter.



This Product Fits:
Porsche 964 3.6L C2 / C4 / RS 1988-94 (Excl. Turbo)


K&N® washable, reusable High-Flow Air Filters™ feature a state-of-the-art design of layered, oiled cotton media engineered to improve airflow and capture contaminants, and are designed to provide an increase in horsepower.

Each performance air filter is reusable, engineered to last for the entire lifespan of your vehicle, and backed by K&N's 10-Year/Million Mile Limited Warranty.

K&N drop-in replacement filters are designed to install easily into your factory air box.

Works with Original Equipment Manufacturer Vehicle Electronics.

Environmentally Friendly, K&N Reusable Air Filters

Upgrade today and start enjoying superior airflow and superior performance from K&N's most popular product!

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

33-2077

The product you are viewing cross references to these numbers

Distributor Vent Kit.

964 Ventilation Kit includes:
- Distributor ventilation connection (A)
- Rubber Grommet (B)
- White Grommet connector (C)
- Hose (D)

HOW TO FIT: Firstly prise of the oval plate arrowed on the distributor with a screwdriver. Then remove the large black air guide pipe as we need to drill a hole in it at the green dot. The pipe removes by loosening jubilee clips at top and bottom. You will also need to remove two sensor connectors on the pipe. I also removed the two sensors near the distributor so that I had easy access to the plate. Drill at 18mm hole in the pipe, 40mm to the right of the tail light ventilation nipple. Deburr the hole and remove all shavings. Install the rubber grommet (B) into the hole and install the white connector (C) into the grommet.Install the distributor connector (A) into the hole in the distributor where the plate was. Finally refit the air pipe and connect back up all the sensors. Install the hose (D) onto the new distributor and air pipe nipples and route

Fits:
Porsche 964 1990-94
Porsche 993 1995-97

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

00004320252

The product you are viewing cross references to these numbers

This a replica of the Porsche Germany RS lightweight factory heat duct that was used on all 3.6 liter special RS lightweight rare cars.

The Porsche part is ugly roto-formed cheap plastic with parting lines whereas accurate replica is carbon fiber.

Saves 8 to 9lbs about 4Kg from the rear of all 964's and 993's. Will not work on C2 Turbos/965 cars.

Replaces blower motor assembly and ductwork and still allows plenty of heat just like the factory RS part.

Ultra cool clear coated real carbon fiber tube that really cleans up engine bay and makes working on engine easy.

Please Note:

All late model 993's 1996-98 (Varioram engines) require the 964 early type fan air guide shroud (as shown on exploded image)
Can be added below

Due to manufacturing tolerances and the nature of composite materials, minor trimming of excess material may be required during installation to ensure optimal fitment.  

Fits:
Porsche 964 C2/C4 1989-1994
Porsche 993 C2/C4 1994-1997

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

964167003

The product you are viewing cross references to these numbers