Intake Plenum + Air Induction Kit Porsche 997 3.8L  ❭  IPDKIT99702

Intake Plenum + Air Induction Kit Porsche 997 3.8L

IPD
Porsche’s new DFI (Direct Fuel Injection) intake is a totally and completely redesigned intake system developed to deliver improved performance, fuel consumption and emissions by optimizing the air fuel mixture directly inside the combustion chamber.

The DFI Porsche engine package is a finely tuned performance machine and additional power has proved difficult to find. The unique design of Porsche’s new DFI intake system posed very challenging tuning hurdles but once again IPD developed a design that out performs the factory intake system without compromising reliability and drive-ability.

This innovative and revolutionary IPD DFI Intake Plenum employs the patented “Y” design as well as an enlarged plenum area that allows for improved intake air speed and velocity resulting in performance increases without any loses in power.
The all new specifically designed IPD 3.8L DFI intake Plenum is a direct bolt-on upgrade that replaces the factory air intake distributor and utilizes all pre-existing factory hardware and throttle body.

The improved IPD intake design allows for smoother, less turbulent and more efficient air flow resulting in impressive power and torque gains for Porsche driving enthusiasts.

The superior design of the DFI IPD Plenum provides an additional 15 horsepower at the wheels. Unlike previous naturally aspirated IPD plenums that delivered stronger gains in the mid range, the new IPD DFI Plenums deliver a similar shaped power curve as the factory but are considerably stronger from the mid range to redline without any loses in power down low.

Installation of the new IPD 3.8L DFI Plenum is relatively straight forward and can be installed by mechanically inclined DIY customers although IPD strongly recommends installation be performed by a trained and qualified Porsche technician.

Induction Kit
As tested on a Mustang Dyno, our subject car was a 2009 PDK 997.2 Carrera running on 91 octane in an ambient temperature of 95F. The car baselined at 291rwhp and 249ft/lbs of torque. It dynoed at 305rwhp and 258ft/lbs of torque for a gain of 14rwhp and 9ft/lbs of torque after the intake was installed. The Mustang dyno has a 15% drive train loss, so the crank horsepower gain is 16bhp. This cold air intake works with all 2009+ DFI Porsche 997.2 Carrera and Carrera S cars.

Fits:
Porsche 997 Gen 2 Carrera 3.8L